How to install tesla style screen car radio for Ford Everest and 2015-2021 Ranger

1. Remove the air outlet on the upper right side(which is a single unit; be careful with the force when operating)

2. Remove the left air outlet of the air conditioner

3. Remove the lower side panels on the left and right sides of the center console.

4. Remove the central console middle decorative cover plate.

5. Remove the lower cover plate of the cigarette lighter.

6. Remove the six fixing screws from the central control panel.

Note：There are also two screws for fixing at the bottom of the panel.

7. Remove the original car screen and the main unit's eight screws, then take out the CD player and the display.

8. The original car air conditioning panel needs to be removed and retained from the control panel, it is essential to keep the original car air conditioning panel. Remember!!!    Remember!!!       Remember!!!

Remove the rear cover retaining screws

Remove the air conditioning board.

Need to keep the original air conditioning board, pay attention to the package when installing, do not cause a short circuit

Power cable connection

1.USB and CAN2/CAM plug docking (The USB interface needs to betrimnmed to match the originalcar plug)

2.Connect the power cord with the radio antenna.

Original USB power plug docking steps:

Remove the center console cover.

Dock the USB Power plug an the powercord to the original socket location

Method of connecting the double flash: Connect the wiring at the air conditioner plug, and connect the double flash extension line to this line.

Install the device in the original car's interior position.

Install the right side trim panel, which comes with the machine.

Install the decorative panel on the left side

Install the ashtray cover back in place to complete the installation.

Installation completed